Burgess Marine Top Gloss 500ml

Burgess Marine Top Gloss is formulated from similar, but harder, resins
to those used in Woodsealer. This gives a crystal clear gloss finish if applied
over the matt finish of Woodsealer. Burgess Marine Top Gloss is ultra violet
stable but does not have UV blockers and so for exteriors should be used over
the top of Marine Woodsealer.

Product Benefits
Crystal clear gloss finish
Ultra Violet stable
For interior and exterior use

Product Usage
For use as a Top Gloss coating over Burgess Woodsealer and Clearsealer

Directions for Use
For internal use Top Gloss must be applied to clean, dry wood. For external use
or surfaces exposed to sunlight always use Burgess Marine Woodsealer as a
primer before applying Top Gloss. Top Gloss dries very quickly. Air bubbles may
not have time to escape and become trapped. To avoid this use a good quality soft
dense brush or lint free cloth. Apply thin coats with minimum brushwork. In hot conditions
it may be beneficial to dilute Top Gloss with water, about 10 percent by volume, to slow down
drying time. A second coat can be applied after 30 minutes if drying conditions are good
low humidity, temperature above 10 degrees C and well ventilated.
Allow to cure for 24 hours before exposing to moisture. If the wood surface is not dry before
applying Top Gloss or the surface is wetted before fully cured, Top Gloss will
bleach ie. turn milky.

Do not despair, unlike blooming in solvent based varnishes, when
conditions permit Top Gloss will dry to a clear finish.
Clean brushes, spills etc. with water before the product dries. Use petrol or thinners to
remove dry spots.